The XLS gauges are programmed with a dedicated software and are completed with a display unit, a remote control, fixturing to hold the part and a base-plate for bench-top use: using this “Table-Gauge” assembly you can, in a few seconds, check the diameter, roundness and the concentricity of ground or turned parts, to an accuracy that before only could be obtained in a metrology room, by using much more expensive equipment and specialized personnel.
Our Performance
It measures the diameter and the ovality of the part
It also measures the center position and the section concentricity
It checks the pre-set tolerances
It sends the measured data to a PC, through the RS232 or Ethernet link