Trang chủ Thiết Bị Đo Lường Điện Thiết bị hãng Advanced energy

Precision Non-Isolated Filament Supply FIL Series Advanced energy

Mã sản phẩm: FIL Series |
Thương hiệu: Advanced energy

Giá bán: Liên hệ

The FIL Series is a non-isolated precision filament supply. This line of regulated DC-DC converters addresses the needs of the high precision and high stability power supply user. Designed and built utilizing a state-of-the-art power-conversion topology, these units feature surface-mount technology and encapsulation techniques that provide high reliability and low cost.

Yêu Cầu Giá Tốt

Zalo/ Tell : 0984.843.683

Email: hien@ttech.vn

Thông tin sản phẩm

Typical Applications	Features
Mass spectrometry Electron beams Test equipment	High precision and high stability 15PPM temperature coefficient 0 to 5VDC 0 to 3 Amps of current Maximum Iout capability down to 0 Volts Programmable voltage and current controls Indefinite output short-circuit protection Buffered output current & voltage monitors Excellent linearity & accuracy of control Current mode and voltage mode indicator Synchronizable

Input

Parameter	Conditions	All types/models
Operating range (VDC)	All conditions		+24 ± 10
Current (mA)	Full load output		900mA typical

Output

Voltage range (VDC)	Nominal input	0 to 5
DC current range (amps)	Nominal input	0 to 3
Voltage range (VDC)	Derated	0 to 5.7
DC current range (amps)	Derated	0 to 3.3
Voltage monitor scaling (VDC)	Full load	10
Current monitor scaling (VDC)	Full load	10

Programming and Controls

Input impedance (MΩ)	Nominal input	+ Output models 10MΩ to GND
Adjust resistance (Ω)	Typical potentiometer values	10K to 100K (Pot across Vref. & Signal GND, Wiper to Adjust)
Adjust voltage (VDC)	Referenced to signal ground	0 to +10 VDC
Accuracy (amps)	In current control	±0.1%
Offset (VDC)	Voltage control	0.04%
Offset (amps)	Current control	0.001%
Output voltage (VDC)	T=+25°C, Initial Value	+10.0V ± 0.05%
Enable/disable (VDC)		0 to +0.5 Disable, +2.4 to 10 Enable (Default = Enable)

Environmental

Operating (°C)	Full load, max Eout, case temp.	+10 to +45
Coefficient (PPM/°C)	Over the specified temperature	≤15
Thermal shock (°C)	Mil-Std 810, method 503-4, Proc. II	-40 to +65
Storage (°C)	Non-operating, case temp.	-55 to +85
Altitude	Standard package, all conditions	Sea level through vaccuum
Shock (G's)	Mil-Std-810, Method 516.5, Proc. IV	20
Vibration (G's)	Mil-Std-810, Method 514.5, Fig.514.5C-3	10