Trang chủ Thiết Bị Môi Trường Thiết bị hãng SWR Engineering

Online humidity measurement M-Sens 2 SWR Engineering

Mã sản phẩm: M-Sens 2 |
Thương hiệu: SWR Engineering

Giá bán: Liên hệ

The M-Sens 2 is used for the continuous measurement of humidity on solids of all kinds.
The M-Sens 2 sensor can ideally be used, for example in container outlets, conveyor belts, conveyor screws, mixers and conveyor dryers.
It is important that the measuring surface of the sensor is always covered with material. The M-Sens 2 is a contact-measuring procedure. The ceramic disc (measuring surface) must always be covered with material.

Yêu Cầu Giá Tốt

Zalo/tell: 0984.843.683

Email: hien@ttech.vn

Thông tin sản phẩm

The microwave sensor for continuous humidity measurement
in dry bulk solids

Simple retrofitting for measurement in container outlets, conveyor screws, on conveyor belts, slides etc.

Humidity ranges 0 ... 65 % (depending on material)
Measurement accuracy 0.1 %
Online humidity measurement
Independent of the material flow
Temperature-resistant up to 120 °C
ATEX-certified
Recording of surface humidity and capillary humidity

Sensor	Housing	Stainless steel 1.4571
	Sensor surface	Ceramic
	Protection category	IP 67 according to EN 60529
	Ex-protection (optional)	Zone 20 (dust), zone 0 (gas)
	Material ambient temperature	0 ... + 120 °C
	Working pressure	max. 10 bar
	Power consumption	0.6 W
	Weight	approx. 1.0 kg
	Response time	0.1 seconds
	Measuring range	0... 65 % residual moisture (depending on material)
	Accuracy	0.1 % absolutely in the calibrated measuring range
	Connecting cable	shielded cable 4-wired, 0.25 mm²
		V Transmitter\|Power supply\|110/230 V AC (50 Hz) 24 V DC \|Power consumption\|20 W / 24 V \|Current consumption\|max. 1 A at 24 V \|Protection category\|IP 65 according to EN 60529/10.91 \|Operating temperature\|- 10... + 45 °C \|Dimensions \|258 x 237 x 174 mm (W x H x D) \|Weight\|approx. 2.5 kg \|Interface\|RS 232, RS 485 \|Cable glands\|3x M16 (4.5-10 mm Ø) \|Cable cross section\|0.2 - 2.5 mm² [AWG 24-14] \|Current output signal\|1 x 4 ... 20 mA (0 ... 20 mA), load < 500 Ohm \|Switched output measuring alarm\|Relay with two-way contact max. 250 V AC, 1 A \|Digital inputs\|2 inputs for active external control signals \|Data protection\|Flash \|\|