- Construction
The MGA 1030 contains three independent modules:
+ Signal generator DC - 250 kHz
+ Power amplifier max. 800 W
+ Spectrum analyzer 16 Bit
All three units can also be used as "stand-alone" devices
- Full automatic testing : In combination with a Triax-Helmholtz coil can be tested EUT in 3 axis without rotating the EUT. Magnetic field strenghts up to 1000 A/m at frequencies from DC to 1 kHz are possible. Smaller field strenghts can be achieved up to 250 kHz
- Calibration of a Helmholtz coil : In combination with a loop sensor (RLS 133 or LS 133), the Helmholtz coil can be calibrated. It can also custom coils are used. A calibration routine in the software of the MGA 1030 allowed linking of additional test agents.
- Self-calibration : Using an ultra-stable voltage source self-calibration correction values are stored in an internal EEPROM. Any voltage signal or voltage measurement device is calibrated as a self-calibration process automatically in about a minute.