| Model name |
Digital counter |
Analog output corresponding
small counter |
| SPS |
KPS |
KPS-P |
CNT-3921 |
 |
 |
|
|
| Number of display digits |
6-digit (- including the display)
red 7-segment LED
character height 10mm |
± 7 digits / red 7 segment LED / character height 15 mm |
6-digit / 7-segment LED
red, green selectable
character height 14.2mm |
| Count value reset |
Reset by manual switch and external control signal |
Reset by external control |
| Count range |
Length measurement + 999999～ -99,999
angle ± 360.00 ° |
Measuring ± 9999999 angle ± 360.00.00 °
measurement: 10-binary |
Measuring Tasu999999
~ -199 999 |
| Count mode |
Angle 1 · 5 · 10 min · 0.01 · 0.1 / 1 ° reading |
Angle 1 · 10 · 15 · 30 sec · 1 · 5 · 10 min · 0.01 · 0.1 / 1 ° reading |
Length measuring decimal |
| Others: Tachometer / Speedometer |
| Decimal point position |
Optional setting by parameter setting |
| Lead value |
Optional setting by parameter setting |
| memory |
Backed up by the non-volatile memory
(about 10 years from when the power is OFF) |
By an internal battery
for a month hold |
| Key switch |
Clear · digit · UP |
Preset · digit · UP · DOWN
|
- |
| Power supply voltage / power consumption |
AC 100 to 240 V ± 10% 50/60 Hz 5 W |
AC100 / 115/200 / 230V DC9.6~30V 8VA following
orders at the time specified |
| Encoder power supply |
DC 12 V 100 mA |
150MA DC12V /
DC5V 100MA (optional)
|
· 100MA DC5V /
DC12V · 50MA
is specified orders |
| Response frequency |
5KHz / 50KHz / 500KHz
(parameter settings) |
250 kHz |
| Rotation number indication |
Rpm number of encoder shaft rotation displayed |
| Display speed |
Speed display mm / minute by the rotary encoder or a linear encoder
peak hold: Display the maximum value of the count value
Bottom hold: count value display the minimum value of the
amplitude display: The maximum value of the count value - Displays the minimum value |
| External control signal |
Reset, preset |
Reset · Inhibit · Preset · Multiplier operation · Millimeter / scale display switching · Milli / inch display switching |
|
| Parallel output |
- |
- |
28bit / SIGN / strobe |
- |
Parallel output
update time |
- |
- |
About 1 ms |
- |
| Operating temperature |
0 to 45 ° C |
| Operating humidity range |
RH 35% to 90% (no condensation) |
- |
| Storage temperature |
-20 to 80 ° C |
| Mass |
About 200G
(including mounting bracket) |
About 270G
(including mounting bracket) |
Approximately 700 g |
| Anti-vibration |
49M / S 2 in 30 minutes |
- |
| Impact resistance |
Durable 294M / S 2 X · Y · Z each direction 3 times |
- |
| Output point |
- |
2 points output |
| Output Capacity |
- |
|
Photo MOS relay
MAX DC350V 80MA
MAX AC240V 80MA
(resistive load) |
| Output signal timing |
- |
40 ms or more after latch hold signal input |
2 level output |
| Analog output |
- |
0～10V / ± 10V /
1 to 5 V / 4 to 20 mA
(specify when ordering) |
| Output update time |
- |
About 1Ms
(maximum delay time 3ms pulse input - analog output) |
| Output rate |
- |
0 Offset and full scale value can be set internally |
| resolution |
- |
Approximately 10000 times (0 to 10 V) |
| Load resistance |
- |
When the voltage output
4 . 7Keiomega or more
when the current output
560Ω or less |
| Output accuracy |
- |
Within ± 0.2% FS (23 ° C) |
| Humidity coefficient |
- |
Within ± 200 ppm / ° C |
| option |
- |
EX-2 or TC-1 |
CK-4-2 |
- |
| RoHS Directive |
Correspondence |
-
|