Two Channel Remote 0-20mA Inputs P2520 Comet

Two-channel 0-20mA
Ethernet interface
The measured current (0-20mA or 4-20mA) can be converted to the physical quantity that is measured by the connected sensor
The converter is galvanically isolated from the Ethernet communication lines, current inputs and power supply are not galvanically isolated.
The instrument may send also a warning message if the measured value exceeds adjusted limit
The alarm states are also displayed on the websites
The device setup can be made by the TSensor software

Specifications

Comet P2520 Specifications
Technical parameters	Value
Output	Ethernet
Measured Value	0-20mA
Construction Type	For External Probes
Design	Industrial
Temperature Measuring Range	to °C
Relay Output	No
Two-State Input	No
Lcd Display	No
PoE	No
Accuracy of current measurement	±0.1%FS from 0°C to +50°C ±0.3%FS from -30°C to +80°C
Resolution	1uA
A/D converter resolution	24bit sigma-delta
Input impedance	20Ω
Measuring interval	1s
Temperature operating range	-30 to +80°C
IP protection	IP30
LAN connection	RJ-45 connector, 10Base-T or 100Base-TX
Communication protocols	WWW, ModbusTCP, SNMPv1, SOAP, XML
Protocols for alarms	E-mail, SNMP Trap, Syslog
Configuration	WWW configuration
Power	9V to 30V, max. power consumption 1W without current sensors
Power connector	terminals inside
Dimensions	88.5 x 126 x 39.5 mm (W x H x D)
Weight	approximately 150g
Warranty	3 years