REFLOW SIMULATOR SRS-1C Malcom

● The top surface of the original heater control matrix, the optimal temperature distribution in the heating test 
    can also be unbalanced heat capacity with respect to the substrate.
● For each stage as well as temperature, time can be arbitrarily set, you can freely extend the time of peak reflow 
    temperature maintenance.
● The observation windows on three sides and top of the front and back of the device, can be observed 
    in the furnace during operation Mokushi the state.

Item	Specification
Model Name	SRS-1CS
Applicable Circuit Board	Up to 70W x 70L x 10H mm
Outer Dimension	Main Unit : 320W x 285D x 310Hmm  Controller unit : 290W x 235D x 270Hmm
Heating Method	Upper-face : Hot air  Lower-face : Extreme infrared radiation
Cooling Method	Flowing air or N2 air (with flow adjustable valve)
ower Supply	200V 50/60Hz 3kVA 3Phase
Air	0.3 - 0.5MPa 100 liter/min (Maximum)
O2 Concentration in Furnace  (when using N2)	100ppm minimum (Heating furnace is sealed up)
PCB Installation	Flat plate system
Upper-Heater	hot air heater : Approx. 2.8kW (Approx. 350W x 8 series)  * Deviation to standard nozzle can be set.
Lower-Heater	Extreme infrared radiation heater : Approx. 360W
Temp. Accuracy	5C maximum (Maximum range : 50(W) x 50(L)mm in the center)
Measuring Temp. Range	Room temp. - 330C
Measuring Points	3points
N2 Gas Supply Function	25 liter/min. with flow regulating valve during operation.
Control	Exclusive softwarefor Windows XP
Weight	Main unit : Approx. 12kg Controller unit : Approx. 8kg

• * The above specifications are subject to change without notice.