Overview:
Multi-Unit Automatic hardness testing system has been designed for labs, which need to perform hardness tests according to different hardness scales.
The hardness testing unit to be used must be placed in the front position by rotating the top part of the support. The rotating system permits to interchange the test unit within a few seconds. No dismounting or re- placement of delicate parts and no specific training are required to per- form with full safety this operation. This solid technical solution is ideal even in the case that the change of unit must be done many times in the same day.
The solid construction of the instrument, the high quality sensors and the lifting system with ball screw makes it ideal both for research purposes and for heavy-duty production control.
Standards the instrument complies with
Shore: ISO 868, 7619-1, ASTM D 2240, DIN 53 505 IRHD and Micro-IRHD: ISO 48; ASTM D 1415; DIN 53 519
Available Hardness types
Shore A, Shore D, Shore 00, IRHD (Normal, Hard, Low), Micro-IRHD
Unit control
Software or Electronic console
Test modality
Fully automatic test in different points of the same sample
Test results calculated for each test
Shore A /Shore D /Shore 00: Initial hardness, hardness values after customer defined test times IRHD /micro IRHD: Hardness after 30 sec, hardness values after customer defined test times
Measure units and resolution
Shore: 0.1 Shore Point IRHD: 0.1 Irhd Point
Calibration
Report with traceability to primary references ACCREDIA calibration Certificate (optional)
Power supply
220 VAC ±10%,50 Hz ±3, 4 A,single phase, 40W - 110 VAC ±10%, 60 Hz ±3 on request
Dimensions
(W x D x H) 350 x 350 x 700 mm