Overview:
The abrasion test gives a comparative evaluation of the resistance to the abrasion of specimens made of vulcanised rubber, plastic and different materials.
The abrasion on a standard specimen is obtained through the use of a certified abrasive paper on a rotating drum with a standard test cycle.
A millesimal scale (not included) is needed to calculate the reduction in volume of the specimen.
Instrument characteristics:
The Abrasion Check is supplied with weights of 0.5 and 1 kg to carry out different tests foreseen by the standards
The protective front panel ensures the instrument is in compliance with EU safety requirements
The drum's release system facilitates replacement of the abrasive paper and cleaning of the instrument.
The special design of the sample holder with regulation of closure ensures correct holding of the sample.
The instrument is supplied with an electronic motor controller for precise regulation of the drum’s rotating speed
Standards the instrument complies with
ISO 4649, DIN 53 516, ASTM D 5963
Test Type
Test with/without sample holder rotation Test with 500 or 1000 g load
Safety Devices
Polycarbonate cover of the drum with automatic safety block Safety pushbutton
Sample Holder
Sample holder with closure regulation
Power Supply
220 VAC ±10%,50 Hz ±3,4 A,single phase - 110 VAC ±10%, 60 Hz ±3 on request.
Motor Reducer
The electronic motor controller installed ensures precise control of rotation speed
Dimensions
(Width x Depth x Height) 950 x 380 x 420 mm
Drum release
The Mechanical release of rotating drum facilitates emery cloth replacement and instrument cleaning
Calibration
Calibration Report with traceability to primary standards
Notes
A millesimal scale (not included) is used to calculate the reduction in volume of the specimen